Табло Dash2
Табло Dash2
Racing Dash2
LD Performance
You shop, we pay for the shipping
416.00 BGN
With VAT and shipping included. Discounts are calculated at payment.
  • Mastercard
  • Visa

Guarantee safe & secure checkout

Overview

  • Displays 7 engine parameters at a time
  • High visibility large display
  • Many parameters to choose from (see list)
  • LED bar at the top shows RPM and works as a shift-light
  • Compatible with many standalone ECUs
  • Works with additional temperature and pressure sensors as well as EGT for exhaust gas temperature measurement
  • Easy to connect and tune
  • Each parameter has a safety warning level
  • Size 175x98x20mm
How to use
  • Connect 12V (ignition ON) and ground wires to the device.
  • Connect CAN bus wires (CANH and CANL) OR serial port cable to ECU
  • Connect any additional sensors according to the wiring diagram (If needed)
  • Use the Configuration Software to change positions or set warning levels
DATA from ECU
  • RPM
  • BOOST
  • AFR
  • TPS
  • Coolant Temp
  • Air Temp
  • Injector ms
  • Injector Duty Cycle
  • Spark angle
  • Battery Voltage
  • OIL pressure
  • FUEL pressure
  • OIL temperature
  • Vehicle speed
  • Gear
DATA from SENSORS
  • AFR – 0-5V input compatible with most wideband controllers and LDperformance wideband
  • RPM – Detects RPM from tachometer (or 5v ignition coil)
  • Coolant / Air / OIL temp – 1/8npt temperature sensor available
  • OIL / Fuel pressure – 1/8npt pressure sensor available up to 10 bar (150psi)
  • EGT – Exhaust gas temperature measurement – EGT probe available separately
  • GPS module - shows vehicle speed in kph or mph
  • Battery voltage
  • Device temperature
  • External signal Duty cycle and time low
Pinout
pinout23
Functions & Hardware
RPM
The unit can detect engine RPM using the tachometer signal. This could be available at the ECU or the ignition module of the car. Alternatively, a signal wire going to an ignition coil or injector could be used.
Temperature
LDperformance RACE DASH has 3 temperature inputs - Coolant, Air and Oil. They are identical. Suitable sensor is available from LDperformance.
Pressure
Three inputs are available – OIL and Fuel Pressure and Boost. These use 3 wire sensor available from LDperformance. The sensor measures up to 10 bar (150psi)
Serial Port
The wiring harness includes a serial port cable. It can be used to get data from the ECU or to configure the DASH from a laptop using USB to serial adapter. The GPS module also connects to the serial port so it is not possible to use GPS and connect to an ECU through the serial port at the same time!
CAN BUS
Used to connect to most ECUs.
GPS
Additional GPS module is available. The gps module is connected to the serial port cable. It's used to read vehicle speed in kph or mph. The old type gps module is connected like this:
gpsWiring
EGT
Dash2 can also read EGT sensor directly. All that is required is to connect EGT probe according to the wiring diagram. Polarity is important – it will not work if the wires are reversed.
AFR
The input is 0-5V which corresponds to 7.4 – 22.5 AFR commonly used by wideband controllers as well as the LDperformance Wideband Controller.
Wiring Diagram
wiring23